Hi Michael, So I forced the

Home › Forums › Hi Michael, So I forced the

April 6, 2012 at 5:55 pm #7079
SirBrady

    Hi Michael,

    So I forced the Promiscuous mode above for BOTH the wireless adapter and Ceton card. Still doesn’t work…These are the steps I followed:

    1. Manually changed the Ceton device from “Default IP Settings (DHCP Server)” and changed it to a Static IP.
    2. I then manually bridged the Ceton Card and Wireless router.
    3. Went through the steps above to force Promiscuous mode.
    4. Was then able to SUCCESSFULLY go through the entire network wizard mode. Finally! But…
    5. Afterwards, I set up my TV signal and no matter what channel I switched to on my TV I would get: “Service is unavailable…There is currently no TV signal detected for this channel. The channel maybe temporarily off the air. Try again later”

    I went through trying to fix this for about 2 hours and finally gave up. I was able to collect a Ceton diagnostics though. By the way, the Ceton diagnostics page reported everything as green. Even when I entered a TV channel to test in the box, it would complete successfully. The Ceton webpage also reported that tuner 1 was tuned.

    Also, the only step I skipped when manually setting up my bridge was going to the Ceton device and enabling “support bridging.” That immediately crashes my system before or after I set up the bridge still.

    Would including the diagnostics report here help?

    Thanks!