wrbrd

[wrbrd]

All good now. Bad reg entry. Thank you!

[wrbrd]

Update – I can get the channel to change using the cmd line with “channel -v -f 2 ###” I checked the reg entry and it is “-v -f  2 %c”. MCE still does not change the channel.

[wrbrd]

I may have flubbed a step or something but I did get the driver to load this time and my device manager does look like that now. Thank you. The computer still won’t change the channels on the STB. After I enter the new channel my PVR goes off and MCE says no signal, then weak signal, and stays on the original channel.

[wrbrd]

Update – The drivers do not install on the unknown devices. When I try it says they are installing but when I go to the properties it says No driver installed even after a restart.

[wrbrd]

Thank you. Yes, that is what I was doing. It kept telling me that the best drivers were installed. Being this is my first time with Win7 I did not know how to stop it from installing some default drivers. I figured it out. I got it to install the drivers, I think. My device manager now reports under imaging devices:

AC Tuner Device

Unknown IEEE 13945068 Device

Unknown IEEE 13945068 Device

Unknown IEEE 1394989 Device

There are no warning flags. I have tried to change channels with the MCE remote, the keyboard and the guide. It shuts down my PVR box then MCE reports that there is no signal. The PVR comes back on the same channel it was and MCE shows the channel is changed.

[wrbrd]

Thank you for sending the link. I still can’t seem to get it to work. Even though I can install the driver it seems it is the same driver I had installed. In device manager under Imaging Devices it reports:

AV/C Tuner Device

Unknown IEEE5068 Device

Unknown IEEE989 Device

Under Other Devices it reports:

Pace RNG110 AVC Panel

It shows a yellow warning symbol. I have tried removing the drivers and restating. On the restart windows installs the imaging device drivers and fails on the AVC Panel driver.

 

[Author]

Posts